Torque efficiency of different archwires in 0.018- and 0.022-inch conventional brackets.

Sifakakis, Iosif; Pandis, Nikolaos; Makou, Margarita; Eliades, Theodore; Katsaros, Christos; Bourauel, Christoph (2014). Torque efficiency of different archwires in 0.018- and 0.022-inch conventional brackets. Angle orthodontist, 84(1), pp. 149-154. Angle Orthodontists Research and Education Foundation 10.2319/021713-138.1

[img]
Preview
Text
AngleOrtho.pdf - Published Version
Available under License Publisher holds Copyright.

Download (181kB) | Preview

OBJECTIVE

To compare the archwires inserted during the final stages of the orthodontic treatment with the generated moments at 0.018- and 0.022-inch brackets.

MATERIALS AND METHODS

The same bracket type, in terms of prescription, was evaluated in both slot dimensions. The brackets were bonded on two identical maxillary acrylic resin models, and each model was mounted on the orthodontic measurement and simulation system. Ten 0.017 × 0.025-inch TMA and ten 0.017 × 0.025-inch stainless steel archwires were evaluated in the 0.018-inch brackets. In the 0.022-inch brackets, ten 0.019 × 0.025-inch TMA and ten 0.019 × 0.025-inch stainless steel archwires were measured. A 15° buccal root torque (+15°) and then a 15° palatal root torque (-15°) were gradually applied to the right central incisor bracket, and the moments were recorded at these positions. A t-test was conducted to compare the generated moments between wires within the 0.018- and 0.022-inch bracket groups separately.

RESULTS

The 0.017 × 0.025-inch archwire in the 0.018-inch brackets generated mean moments of 9.25 Nmm and 14.2 Nmm for the TMA and stainless steel archwires, respectively. The measured moments in the 0.022-inch brackets with the 0.019 × 0.025-inch TMA and stainless steel archwires were 6.6 Nmm and 9.3 Nmm, respectively.

CONCLUSION

The 0.017 × 0.025-inch stainless steel and β-Ti archwires in the 0.018-inch slot generated higher moments than the 0.019 × 0.025-inch archwires because of lower torque play. This difference is exaggerated in steel archwires, in comparison with the β-Ti, because of differences in stiffness. The differences of maximum moments between the archwires of the same cross-section but different alloys were statistically significant at both slot dimensions.

Item Type:

Journal Article (Original Article)

Division/Institute:

04 Faculty of Medicine > School of Dental Medicine > Department of Orthodontics

UniBE Contributor:

Pandis, Nikolaos, Katsaros, Christos

Subjects:

600 Technology > 610 Medicine & health

ISSN:

0003-3219

Publisher:

Angle Orthodontists Research and Education Foundation

Language:

English

Submitter:

Eveline Carmen Schuler

Date Deposited:

25 Nov 2014 14:51

Last Modified:

03 May 2024 15:07

Publisher DOI:

10.2319/021713-138.1

PubMed ID:

23678999

BORIS DOI:

10.7892/boris.60578

URI:

https://boris.unibe.ch/id/eprint/60578

Actions (login required)

Edit item Edit item
Provide Feedback